Petway Spacer Rubber Tape

$4.50
Thickness
Size

The foam tape is applied to create a tight seal between the pet door frame and the screen or glass, helping to prevent gaps, vibration, weather and drafts. 

  • Compatible with stainless steel mesh and glass doors/windows 
  • PVC nitrile single sided foam tape 
  • Water and weather proof
  • Compatible for Petway Pet Doors made for Security Screens and glass
  • 10mm wide
  • Comes in two thickness to fit most screen doors
  • Easy to fit with simple fitting instructions 
  • Colour is black to blend in with black mesh
  • 1 x foam tape fits one pet door (2 sides) 

For 5/6mm glass we recommend 3mm thick on the outside frame and 6mm thick on the inside frame for a snug compressed fit, however these can be swapped depending on the door clearance.

Installation on glass requires spacer rubber to be wrapped around the full perimeter of each side of the pet door.

Installation Instructions

Step-by step installation instructions below

Foam Tape
  1. Apply the foam tape to the outer edge of the frame (as shown in diagram above). Tape is required on the top and left-hand side only. 
  2. Start the tape from the top right hand corner and carefully peel back a small section of the protective liner to expose the adhesive.
  3. Press the tape firmly into place at the top of the frame while slowly removing the backing as you go. Avoid stretching the tape. Keep it straight and even.
  4. At the top-left corner, cut a small triangular notch out of the foam tape so it can fold neatly and form a clean L-shape without bunching. 
  5. Press the tape firmly down the left hand side of the frame. When you reach the bottom corner cut off cleanly.
  6. Repeat the same process on the matching side of the other frame. 

For further instruational videos visit our dedicated installation instructions page

Australian Made
Ship Worldwide
View details